Discrete shipping above €150
Personal advice In our office
Installation service by our professionals
14 days B2B ship back

PoE switch for CCTV IP cameras

Shipping within 48 hours

This Ethernet Switch has a 5- port 10/100 and a 4-port PoE port. 
All 4 the PoE Ethernet ports consumed 15.4 Watts and has a data transmission of 10/100Mbps. 
To connect to the Ethernet interface you can use Cat 5/Cat 5e/Cat 6 cables. 
The Switch can easily be used with IP cameras, but also with wireless access points (APS).
It is ideal for installations where there is no wall outlet available.

There is no configuration required and installation is quick and easy. 
Support for Auto-MDI/MDI-X on all ports and eliminates the need for cross-over connection for another switch or HUB.
The speed is intelligently adjusted so that the device is always looking for the most optimal performance.

The 5-port 10/100 Ethernet Switch PoE supports five 10/100Mbps Ethernet ports. 
Port 1 to 4 of the port are PoE enabled ports.
Each port contains 10/100Mbps support via UTP CAT5/5e cables. 
The four PoE ports are automatically activated when a compatible device is identified. 
The 5-port 10/100 Ethernet PoE Switch will supply power via the Ethernet port on the connected PoE device (PD)

The switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and runs in both half and full duplex mode using two pairs of category 5 or 5e cable.

All ports are Auto-MDI type. The switch can automatically convert to MDII or MDI-X type, so you can use the RJ-45 cable regardless of whether it is a standard or crossover cable. 

PoE supported multiple types of devices such as wireless LAN access points, VOIP telephone and IP security cameras.
PoE is very easy and will save up to 50% time and cost because there is no separate electrical wiring that must be installed. 

-  5 x 10/100Mbps Auto-negotiation fast Ethernet RJ-45 ports with 4-Port PoE function (port 1 ~ 4 port) 
- Compatible with IEEE 802 .3af specification
- Supports PoE PoE ports 56W for consumption up to all
- Supports PoE IEEE 802 .3af compatible powered device (PD)
- Each port supports auto MDI/MDIX, so there is no need to use cross-over cables. 
- Full/half-duplex transfer mode for each port.
- Send and receive
- 64KBytes package buffer

More Information
Warranty3 year
Write Your Own Review
You're reviewing:PoE switch for CCTV IP cameras
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?
(Size: 276.2 KB)
Je rechten en voordelen!
14 days return timeLoyal products
Package point pick it upFree shipping above EU 150!
Intra-Community5 years SST brand warranty
Demo and warehouse in AmsterdamMore than 15 years faithful
Free gift above € 20,-Installing service
Quality checkOutstanding service and always affordable
Recently Viewed
No recently views items
Clear All